What Size Eye Bolts For Porch Swing

In this tutorial, I'k going to teach you how to hang a porch swing. Porch swings can add a lot of graphic symbol to a forepart or back porch, but it's very important to hang them properly. They should be direct, not leaning to one side or the other, and hung from something that can back up the weight.

If y'all're reading this, chances are you already have a swing. Merely if you don't, yous should check out our porch swing plans. They are super like shooting fish in a barrel to build!

Tools and Materials:

three/4″ or ane″ Rope – Two pieces each over double the superlative of the porch ceiling (plus the depth of the swing for a swing bed)
Drill with ane/4″ drill bit
three/eight″ Eye Screws
long screwdriver
2 five gallon buckets or something similar in superlative

Step 1: Determine How Many Screw Eyes are Needed

Eye Screws are what you'll utilize to hang the ropes from the joists. For larger swing beds, I recommend using iv eye screws to support the added weight. But for a smaller swing like the crib mattress swing, ii is all you need.

Step 2: Locate the Ceiling Joists

When hanging a porch swing, it is extremely important that it's hung from the ceiling joists of the porch. The weight of the swing plus the people sitting on it requires something strong for back up.

Locating the ceiling joists can be a challenge, particularly if yous have a material on your porch ceiling that makes it impossible to use a stud finder. Forest is one of these materials.

Every porch that I've hung a swing on has had tongue and groove wood ceilings, which has ordinarily fabricated this pace the most challenging. Simply I've constitute that the easiest mode to locate the ceiling joists with these types of ceilings is to await for nail holes in the t&g planks. This indicates where the planks are nailed to the joists.

Step 3: Determine the Placement

In one case y'all figure out where on the porch you want your swing, you lot so demand to decide exactly where the eye screws need to exist placed on the ceiling. For a larger swing bed, you lot should apply four screw eyes each placed directly above the corresponding holes on the swing.

Measure out between the holes every bit show below so mirror those measurements on your ceiling. On our own porch, nosotros had to avoid the ceiling fans. So I placed the eye screws much closer to each other.

Since the crib mattress swing only required ii eye screws, we placed them in the heart of the front and back holes.

You lot should likewise try to keep your swing at to the lowest degree 24 inches aways from whatsoever walls to avoid hitting the walls.

Step 4: Attach the Screw Eyes

In one case you accept your locations for the heart screws, drill pilot holes for each one.

Next, start screwing the eye screw in past hand. Y'all'll reach a point when it becomes also difficult to turn with your hands. Accept a long spiral driver and put it through the eye and turn. This will give yous extra leverage.

Step v: Hang the Rope

In one case you have both eye screws in place, fish the rope through each one then that each finish is hanging close to fifty-fifty.

Footstep 6: Adhere Rope to the Porch Swing

Find something to sit down your swing on that will concord it a couple of feet above the floor. I like to use 5 gallon buckets. This puts it a little higher than it needs to be, just once you use the swing for a while, the ropes will stretch and your swing will be at the perfect top.

Side by side, fish one end of the rope through one of the holes on the swing, and tie a knot underneath.

Repeat this step for the other hole on the same side, and make sure the knots are snug against the bottom of the swing. And so do the same to the other side.

And that'south it, you're all done!

At present you tin place the cushion and pillows on the swing and savour!